LOCAL CONTROL / MADE SIMPLE

Your heat pump.
Your network.

Bring a compatible Midea XYE system into Home Assistant with a small RS485 gateway. No cloud required.

01Built for the wired systems
you already own.

01 / LOCAL FIRST02 / HOME ASSISTANT + MQTT03 / YOUR WIRED CONTROLLER

THE IDEA

A little bridge.
A lot more control.

Your air handler speaks XYE. Home Assistant speaks MQTT. MideaXYE connects the two and gives you a local web page for setup and status.

01Connect the Waveshare RS485 board to a compatible XYE bus.

02Configure Wi-Fi and your MQTT broker from the device page.

03Discover the climate entity in Home Assistant and set your schedule.

FIRMWARE INSTALLER

Ready when
you are.

Flash from your browser with a USB data cable. Your existing firmware will be replaced.

01 / CONNECT

Plug in your board.

Use a Waveshare ESP32-S3-RS485-CAN and a USB data cable. Connect on a desktop browser that supports Web Serial.

02 / INSTALL

Install MideaXYE.

The installer is ready; the first firmware release is being prepared.

Compatibility matters. Tested with a MrCool VersaPro 2 and KJR-120N wired controller. Other XYE systems need verification. A Home Assistant MQTT broker is required for discovery; the wired controller's room temperature is not currently available.

QUESTIONS?

Let’s figure it out.

Get in touch ↗

Your heat pump.Your network.